Short answer: yes, almost everywhere in King County, and who issues it depends on where you live. Below are the permit questions we get on water heater jobs, answered from the rules the permit offices publish and the replacements we did in 2026.
Do I need a permit to replace a water heater in King County?
Yes, in nearly every case. A replacement water heater is a plumbing or mechanical installation, not a repair, and the permit comes from your city, or from Public Health Seattle & King County in Seattle, Clyde Hill and unincorporated areas. A like-for-like swap is usually a quick over-the-counter permit, and the plumber normally pulls it.
Who issues the water heater permit in Seattle?
Public Health Seattle & King County, not the Seattle Department of Construction and Inspections. Public Health issues plumbing and gas piping permits in Seattle, Clyde Hill and unincorporated King County. When we rewrote our Seattle water heater page this month, that was one of the claims we corrected, because it decides which office inspects your heater.
What changed for water heater permits on July 1, 2026?
From July 1, 2026, Public Health requires a permit for a replacement water heater in its jurisdiction: Seattle, Clyde Hill and unincorporated King County, which takes in Fall City, Preston and the rural land around Duvall and Carnation. For a like-for-like swap it is usually issued over the counter, and the plumber pulls it.
Does a gas water heater need a different permit from an electric one?
In some cities, yes. Kirkland, for example, issues a plumbing permit for an electric water heater and a mechanical permit for a gas one, plus a plumbing permit if the water piping is rearranged and a building permit if a wall, floor or ceiling has to be opened. Other cities bundle it differently, so check yours.
Do I need a permit to replace a water heater in Snoqualmie?
Yes. The City of Snoqualmie lists the "installation, relocation, and replacement of any mechanical appliance, such as water heaters" among the work that needs a permit. The city issues it, not Public Health, and the city inspects. We pull it as part of the replacement, as we did for a Rinnai tankless swap on Snoqualmie Ridge in June.
What does the inspector look for on a new water heater?
Public Health's water heater checklist covers 24 inches of working access, two seismic straps in the upper and lower thirds of the tank, an expansion tank on a closed system, a relief line that drains by gravity, and a separate gas piping permit for gas work. Cities inspect for much the same list.
Can a water heater go in a bedroom or bathroom?
Not a standard gas one. Public Health does not allow a gas water heater that is not direct-vent in a bedroom or bathroom, because it draws combustion air from the room. A direct-vent gas unit, an electric tank or a heat pump unit is the usual answer there. We look at the location before we quote the model.
Does switching from gas to a heat pump water heater need extra permits?
Usually. The water heater needs its own permit, the gas line being capped is gas piping work, and the new 240-volt circuit is electrical work with its own permit, pulled by the electrician. On a June gas-to-hybrid swap in Bellevue, a licensed electrician ran the dedicated 30-amp circuit while Caleb capped the gas line.
Who pulls the permit, me or the plumber?
The licensed plumber normally pulls it, schedules the inspection and meets the inspector. Homeowner permits exist for some work on your own house, but the inspection still has to pass, and most of our customers would rather the installer own both. At Lighthouse Plumbing the permit is part of the price we quote.
Get a Water Heater Replaced Properly
Call 425-549-2400 or schedule an appointment.
More: water heater questions answered · tank vs heat pump water heaters · water heaters in Seattle · water heaters in Kirkland · water heaters in Snoqualmie · water heaters in Sammamish

